6/10/2023 0 Comments Startx samsclass.info![]() In the Linux VM, open a Terminal window and execute these commands. Log in with a user name of root and a password of toorĮnter this command, followed by the Enter key: You could also use DEFT or Kali Linux, but make sure you are using an installed VM, not a boot disk. With a filename of " Proj 5x from YOUR NAME".CNIT 121 Proj 16: Sleuthkit and Autopsy (15 pts.) CNIT 121 Proj 16: Sleuthkit and Autopsy (15 pts.) What You Need for This Project In the Backtrack Terminal window, execute these commands, Number on your machine-note this number.) In the Backtrack Terminal window, execute this command You should see the message "Starting interaction with 1." Replacing the number "1" with the correct number of an open In the Backtrack Terminal window, execute this command, On the BackTrack machine, you should see one or more "session opened" messages, as shown below: If you change network settings, restart the VM or refresh the address with ipconfig /renew on Windows or dhclient on Check VMware network settings-make sure they are both the same-either both NAT or both Bridged. If you can't open the Web page, make sure the two machines are Type the IP address of the BackTrack machine into the Addressīar (without the ":8081") and press Enter. On the Windows machine, in Internet Explorer, Your BackTrack machine's IP address is shown, followed by ":8081",Īs you can see in the figure above. Immediately above the "Starting the payload handler." message, "Starting the payload handler.", as shown below: ![]()
0 Comments
Leave a Reply. |